Laser engraving machine is a high-tech product in the current industrial production field. It is not only used for engraving, but also for other processing operations on the workpiece. In the early 1990s, laser engraving machine was born successfully, followed by the rapid development of laser engraving technology. Up to now, the laser engraving machine has been used in many industries and has become the preferred equipment in the industrial processing field. When using the laser engraving machine to work, some faults often occur due to operational errors. Now let's talk about two common faults and solutions of laser engraving machine.

Field operation of laser engraving machine

Fault phenomenon 1:

When opening the NC panel of the laser engraving machine, the NC system prompts "Board loading failed, please check the board"

resolvent:

1. Check whether the card driver of the laser engraving machine is installed correctly, or insert the card into another card slot.

2. Connect and test the data connection line of the board to see if the pin breaks.

3. If the board fails, repair or replace it in time.

Fault phenomenon 2:

Open the NC system of the laser engraving machine and prompt: three-axis alarm, initialization error 4

resolvent:

1. Check whether the computer of the laser engraving machine is connected to the machine normally.

2. Check whether the fuse of the adapter board in the control box of the laser engraving machine is faulty. If the fuse is counted, it should be replaced in time.

3. Check whether the power supply of the laser engraving machine can work normally.